36 lines
2 KiB
Text
36 lines
2 KiB
Text
; host.choose_material(title:"Choose the material that you are loading.")
|
|
|
|
M106 S0 ; turn off the fan
|
|
M104 S[temperature] ; start heating up the extruder
|
|
|
|
; host.show_message(title:"Trim the end of the filament to ensure a good load.", image:"[trim_image]", wait_ok:"true")
|
|
|
|
M302 S0 ; Allow extrusion at any temperature
|
|
G91 ; Relative positioning
|
|
; host.show_message(title:"Put filament into extruder until you feel it start to feed and then click Continue.", repeat_gcode:"G1 E.1 F150|G4 P10", expire:"90", image:"[insert_image]")
|
|
G90 ; Absolute positioning
|
|
; host.show_message(title:"Loading filament...", count_down:"28")
|
|
G92 E0 ; reset the extruder position to 0
|
|
G91 ; Relative positioning
|
|
G1 E[load_filament_length_over_six] F[load_filament_speed] ; extrude the filament (pulse was 598)
|
|
G1 E[load_filament_length_over_six] F[load_filament_speed] ; extrude the filament
|
|
G1 E[load_filament_length_over_six] F[load_filament_speed] ; extrude the filament
|
|
G1 E[load_filament_length_over_six] F[load_filament_speed] ; extrude the filament
|
|
G1 E[load_filament_length_over_six] F[load_filament_speed] ; extrude the filament
|
|
G1 E[load_filament_length_over_six] F[load_filament_speed] ; extrude the filament
|
|
G4 S1 ; wait for move to finish
|
|
|
|
M302 S150 ; Set cold extrude temp back to reasonable
|
|
; host.show_message(title:"Waiting for extruder to heat to [temperature].")
|
|
G4 S1 ; wait message to display
|
|
M109 S[temperature] ; heat up the extruder
|
|
|
|
; extrude slowly so that we can prime the extruder
|
|
; host.show_message(title:"Click 'Continue' when filament is running cleanly through the nozzle.", repeat_gcode:"G1 E1 F300|G4 P10", expire:"90", image:"[running_clean_image]")
|
|
|
|
G4 S1 ; wait for move to finish
|
|
G90 ; Absolute positioning
|
|
G92 E0 ; reset the extruder position to 0
|
|
|
|
; turn the extruder temperature off if not printing, else leave it at new load temp.
|
|
; host.done_load_unload()
|