Lars Brubaker 0164c1d48e exclude support from lay flat consideration (if there is non-support) ... issue: MatterHackers/MCCentral#3989 Consider excluding support from layflat		2019-03-14 15:19:27 -07:00
..
AboutPage
ActionBar	Enable heater toggles while printing	2019-03-08 07:42:57 -08:00
ApplicationView	Add dedicated popup border color, add or tune theme border color	2019-03-09 13:32:55 -08:00
ConfigurationPage	Enable heater toggles while printing	2019-03-08 07:42:57 -08:00
ControlElements	Add dedicated popup border color, add or tune theme border color	2019-03-09 13:32:55 -08:00
CustomWidgets	Disable recovery on calibration prints	2019-03-14 12:11:35 -07:00
DataStorage	Get baby stepping working for extruder 2	2019-02-11 15:23:41 -08:00
DesignTools	Refactoring	2019-03-11 16:01:12 -07:00
EeProm
History
Library	Add ID property to ValidationError	2019-03-08 16:43:25 -08:00
PartPreviewWindow	exclude support from lay flat consideration (if there is non-support)	2019-03-14 15:19:27 -07:00
PrinterCommunication	Make sure we only use homing endstop for z	2019-03-14 12:25:29 -07:00
PrinterControls	Remove redundant labels	2019-02-19 18:37:31 -08:00
Queue
SettingsManagement
SetupWizard	Add support for explicit WindowSize on SetupWizards	2019-03-06 18:03:38 -08:00
SlicerConfiguration	Add interface layer speed	2019-03-11 13:59:14 -07:00
Utilities	Place access modifiers before override	2019-03-01 18:19:16 -08:00
VersionManagement
MatterControlApplication.cs
MatterControlLib.csproj
PdfSharp.dll
RootSystemWindow.cs	Getting switch extruder pre-gcode to run when needed	2019-02-06 12:34:20 -08:00