; host.choose_material(title:"Choose the material that you are loading.")

M106 S0 ; turn off the fan
M104 S[temperature] ; start heating up the extruder

; host.show_message(title:"Trim Filament", markdown:"[trim_filament_markdown]", wait_ok:"true")

M302 S0  ; Allow extrusion at any temperature
G91                 ; Relative positioning
; host.show_message(title:"Insert Filament", repeat_gcode:"G1 E.2 F80", expire:"300", markdown:"[insert_filament_markdown]")
G90                 ; Absolute positioning
; host.show_message(title:"Loading Filament...", count_down:"[load_filament_time]")
G92 E0              ; reset the extruder position to 0
G91                 ; Relative positioning
G1 E[load_filament_length_over_six] F[load_filament_speed]       ; extrude the filament (pulse was 598)
G1 E[load_filament_length_over_six] F[load_filament_speed]       ; extrude the filament 
G1 E[load_filament_length_over_six] F[load_filament_speed]       ; extrude the filament 
G1 E[load_filament_length_over_six] F[load_filament_speed]       ; extrude the filament 
G1 E[load_filament_length_over_six] F[load_filament_speed]       ; extrude the filament
G1 E[load_filament_length_over_six] F[load_filament_speed]       ; extrude the filament 
G4 S1               ; wait for move to finish

M302 S150  ; Set cold extrude temp back to reasonable
; host.show_message(title:"Waiting for extruder to heat to [temperature].")
G4 S1               ; wait message to display
M109 S[temperature] ; heat up the extruder

; extrude slowly so that we can prime the extruder
; host.show_message(title:"Wait For Running Clean", repeat_gcode:"G1 E0.35 F140", expire:"90", markdown:"[running_clean_markdown]")

G4 S1               ; wait for move to finish
G90                 ; Absolute positioning
G92 E0              ; reset the extruder position to 0

; turn the extruder temperature off if not printing, else leave it at new load temp.
; host.done_load_unload()