LarsBrubaker
8b9da24120
make sure we don't send M109 if already in start gcode
...
issue: MatterHackers/MatterControl#4610
Purge not working correctly
2019-06-15 07:51:26 -07:00
LarsBrubaker
cb81681e4d
Fixing start gcode to have correct intelligence for legacy profiles
...
and still have the correct behavior of pre-heating
start gcode
post heating
2019-05-18 07:25:00 -07:00
Lars Brubaker
22ec3afbc4
Make sure we finish heating the bed before the start gcode
...
issue: MatterHackers/MCCentral#5538
Doesn't wait for bed to reach temp before printing
2019-05-17 18:09:55 -07:00
Lars Brubaker
c867ad96c6
Make sure we issue an M190 rather than M140 when finishing start gcode
...
issue: MatterHackers/MCCentral#5538
Doesn't wait for bed to reach temp before printing
2019-05-16 17:02:16 -07:00
Lars Brubaker
d62f796b52
fixing warnings
2019-05-02 15:36:52 -07:00
jlewin
8d4547d706
Revise naming to match behavior
2019-05-01 15:39:16 -07:00
LarsBrubaker
73ebdde9e5
Changing nozzle1_inset to t0_inset
...
refactoring some surrounding code to talk about tool rather than nozzle
or hotend
figure it's better to do this change before we have any profiles with this set into them
issue: MatterHackers/MCCentral#5333
Consider if Tool nomenclature should be used instead of Nozzle
2019-04-20 21:03:05 -07:00
jlewin
46f8b73d8f
Improve StartGCode heating
2019-03-04 16:46:27 -08:00
jlewin
6f0a60af17
Always switch to target extruder after M104/M109
2019-03-04 16:46:27 -08:00
Lars Brubaker
9f55a1432c
dual extrusion load / unload filament
...
unload filament is actually working on extruder 2
2019-02-05 13:43:04 -08:00
Lars Brubaker
0babdab806
cleaning up MappedSetting
2018-11-14 13:33:25 -08:00
