Merge pull request #245 from gregory-diaz/development

Development

SlicerConfiguration/SlicerMapping/EngineMappingMatterSlice.cs

@@ -213,6 +213,8 @@ namespace MatterHackers.MatterControl.SlicerConfiguration
             new VisibleButNotMappedToEngine("", "has_sd_card_reader"),
             new VisibleButNotMappedToEngine("", "z_can_be_negative"),
             new VisibleButNotMappedToEngine("", "show_reset_connection"),
+            new VisibleButNotMappedToEngine("", "extruder_wipe_temperature"),
+            new VisibleButNotMappedToEngine("", "bed_remove_part_temperature"),
 
             //retractionOnExtruderSwitch=14.5
             new MapItem("retractionOnExtruderSwitch", "retract_length_tool_change"),

StaticData/PrinterSettings/config.ini

@@ -26,6 +26,7 @@ extruder_clearance_height = 20
 extruder_clearance_radius = 20
 extruder_count = 1
 extruder_offset = 0x0,0x0,0x0,0x0
+extruder_wipe_temperature = 0
 extruders_share_temperature = 0
 extrusion_axis = E
 extrusion_multiplier = 1
@@ -90,6 +91,7 @@ raft_extra_distance_around_part = 5
 raft_fan_speed_percent = 100
 raft_layers = 0
 raft_print_speed = 100%
+bed_remove_part_temperature = 0 
 randomize_start = 0
 repair_outlines_extensive_stitching = 0
 repair_outlines_keep_open = 0

StaticData/SliceSettings/Layouts.txt

@@ -43,11 +43,14 @@ Intermediate
     Filament
       Filament
         filament_diameter
-      Temperature (°C)
+      Extruder Temperature (°C)
         first_layer_temperature
         temperature
+        extruder_wipe_temperature
+      Bed Temperature (°C)
         first_layer_bed_temperature
         bed_temperature
+        bed_remove_part_temperature
       Retraction
         retract_length
         retract_speed
@@ -197,9 +200,11 @@ Advanced
       Extruder Temperature (°C)
         first_layer_temperature
         temperature
+        extruder_wipe_temperature
       Bed Temperature (°C)
         first_layer_bed_temperature
         bed_temperature
+        bed_remove_part_temperature
       Retraction
         retract_length
         retract_length_tool_change

StaticData/SliceSettings/Properties.json

@@ -976,6 +976,20 @@
     "DataEditType": "POSITIVE_DOUBLE",
     "ExtraSettings": "degrees"
   },
+  {
+    "SlicerConfigName": "extruder_wipe_temperature",
+    "PresentationName": "Extruder Wipe Temperature",
+    "HelpText": "The temperature the extruder will be when extruder wipes.",
+    "DataEditType": "POSITIVE_DOUBLE",
+    "ExtraSettings": "degrees"
+  },
+  {
+    "SlicerConfigName": "bed_remove_part_temperature",
+    "PresentationName": "Bed Remove Part Temperature",
+    "HelpText": "The temperature the bed temperature will be set to when part is to be removed.",
+    "DataEditType": "POSITIVE_DOUBLE",
+    "ExtraSettings": "degrees"
+  },
   {
     "SlicerConfigName": "thin_walls",
     "PresentationName": "Thin Walls",