slow down the jump start defaults

StaticData/PrinterSettings/JumpStart/V1/config.ini

@@ -13,7 +13,7 @@ build_height = 200
 cancel_gcode = G28 X0\n
 center_part_on_bed = 1
 complete_objects = 0
-connect_gcode = M205 X8\nM201 X1000 Y1500 Z100 E3000\nM204 S0 T1800
+connect_gcode = M205 X8\nM201 X500 Y500 Z100 E3000\nM204 S500 T500
 cool_extruder_lift = 1
 print_leveling_solution = 3 Point Plane
 print_leveling_method = Manual
@@ -69,13 +69,13 @@ infill_extrusion_width = 0
 infill_first = 0
 infill_only_where_needed = 1
 infill_overlap_perimeter = 0.2
-infill_speed = 45
+infill_speed = 40
 infill_type = TRIANGLES
 layer_gcode = 
 layer_height = 0.2
 layer_to_pause = 
 max_fan_speed = 100
-min_extrusion_before_retract = 0.1
+min_extrusion_before_retract = 0
 min_fan_speed = 100
 min_print_speed = 15
 min_skirt_length = 5
@@ -106,25 +106,27 @@ repair_outlines_extensive_stitching = 1
 repair_outlines_keep_open = 1
 resolution = 0
 resume_gcode = 
+resume_first_layer_speed = 10
+resume_position_before_z_home = 0,200
 retract_before_travel = 10
 retract_layer_change = 1
 retract_length = 3
 retract_length_tool_change = 10
-retract_lift = 0
+retract_lift = 0.2
 retract_restart_extra = 0
 retract_restart_extra_toolchange = 0
 retract_when_changing_islands = 1
 retract_speed = 50
 skirt_distance = 3
 skirt_height = 1
-skirts = 4
+skirts = 1
 slowdown_below_layer_time = 20
 small_perimeter_speed = 30
 solid_fill_pattern = rectilinear
 solid_infill_below_area = 70
 solid_infill_every_layers = 0
 solid_infill_extrusion_width = 0
-solid_infill_speed = 60
+solid_infill_speed = 40
 solid_shell = 0
 spiral_vase = 0
 standby_temperature_delta = -5
@@ -158,7 +160,7 @@ toolchange_gcode =
 top_infill_extrusion_width = 0
 top_solid_infill_speed = 35
 top_solid_layers = 4
-travel_speed = 100
+travel_speed = 40
 use_firmware_retraction = 0
 use_relative_e_distances = 0
 vibration_limit = 0
@@ -166,4 +168,5 @@ wipe = 0
 wipe_shield_distance = 0
 wipe_tower_size = 0
 z_can_be_negative = 0
+z_homes_to_max = 0
 z_offset = 0.2